3
DR MODE <BASIC>
3-6
Push D-pad( u ) to select “NAME,” and then push D-
pad(Ent).
Rotate [DIAL] to select a desired character. i
(For example: T)
• The selected character blinks.
• Push D-pad() to move the cursor right or left.
• While selecting a character, push
to change the
character to a upper case or lower case letter.
• While selecting a digit, push
to open the input mode
selection window.
• A space can be selected, even for any input mode se-
lected.
• Push [CLR]
to erase the selected character, or hold
down [CLR]
to continuously erase the characters
after the cursor.
• See page 4-2 for programming details.
Push D-pad( o ") to move the cursor to the second
digit.
!0 Repeat steps i and o to enter a name of up to 16
characters, including spaces.
(For example: First, T, then O, then M.)
!1 After entering the name, push D-pad(Ent).
!2 Push D-pad() to select “<<Add Write>>,” and then
push D-pad(Ent).
!3 Push D-pad() to select “YES,” and then push D-
pad(Ent).
!4 Push [MENU] to exit the [RX HISTORY]
screen.
[DIAL]
“UR” (Destination call sign) programming (Continued) ■
[JM1ZLK] is auto-
matically set
“TOM” setting is completed.
“TOM/JM1ZLK” is
programmed into
the UR call sign
memory.
When “TOM” is selected,
“JM1ZLK” is displayed.
To Next Page
Loading...
