Icom ID-31A

7
MEMORY CHANNEL PROGRAMMING
7
7-11
Rotate [DIAL] to select a desired character. y
• Selectable input characters modes are Upper case let-
ters, Lower case letters, Numbers or Symbols.
• The selected character blinks.
• Push D-pad() to move the cursor right or left.
• While selecting a letter, push
to change the letter
to an upper case or lower case letter.
• While selecting a digit, push
to open the input
mode selection window.
• A space can be entered, even with any input mode se-
lected.
• Push D-pad(") to enter a space to the right of the last
character.
• To insert a space to the left of any selected character,
rotate [DIAL] to select a space to insert it.
• Push [CLR]
to erase the selected character, or hold
down [CLR]
to continuously erase the characters
to the left of the cursor.
Push D-pad( u ") to move the cursor to the second
digit.
Repeat steps i y and u until the desired channel
name is programmed.
Push D-pad(Ent) to save the name and exit the o
Memory name edit mode.
!0 Push D-pad() to select “<<Write>>,” and then
push D-pad(Ent).
• The conrmation screen “Overwrite?” appears.
!1 Push D-pad() to select “YES,” and then push
D-pad(Ent).
• Returns to the screen viewed before entering the Select
Memory write mode in step w.
Continued from the previous
page
Rotate [DIAL] to se-
lect “I”.
Push D-pad(") to
move the cursor to
the second digit.
Rotate [DIAL] to se-
lect “C.”
Repeat steps y and
u until the desired
memory name is
programmed.
Push D-pad(Ent) to
save the name and
exit the Memory
name edit mode.
Select “<<Write>>,”
and then push D-
pad(Ent.)
Select “YES,” and
push D-pad(Ent).
Returns to the screen
viewed before enter-
ing the Select Mem-
ory write mode.
Memory name is dis-
played.
Previous view