10
MENU SCREEN OPERATION
10
10-9
NOTE: The default settings, shown below, are for the USA version.
The default settings may differ, depending on the version.
Function
Power Save
PTT Lock
Monitor
Busy Lockout
Dial Speed-UP
Time-Out Timer
Auto Repeater
MIC Simple Mode
Key Lock
OFF, Auto (Short), Auto (Middle) or Auto
(Long)
OFF or ON
In this item, set other options.
Push or Hold
OFF or ON
OFF or ON
OFF, 1min, 3min, 5min, 10min, 15min or
30min
OFF or ON (DUP), ON (DUP,TONE)
Simple, Normal-1 or Normal-2
Normal, No SQL, No VOL or ALL
DESCRIPTIONS
RANGE OR VALUE (Default is shown in bold)
Selects the Power Save options to
reduce current drain and conserve
battery power.
Selects the [SQL] monitor function
method.
Turns the Auto Repeater function
ON or OFF.
Turns the dial speed acceleration
ON or OFF.
Selects the Microphone simple mode
options.
Selects the key lock type when the
Key Lock function is turned ON.
Turns the PTT Lock function ON or
OFF.
Turns the Busy Lockout function ON
or OFF.
Selects the Time-Out Timer time op-
tions.
VOX VOX
VOX Level
VOX Delay
Headset Select
OFF or ON
1~5~10 or OFF
0.5sec, 1.0sec, 1.5sec, 2.0sec, 2.5sec or
3.0sec
HS-95 or Other
VOX Time-Out Timer
OFF, 1min, 2min, 3min, 4min, 5min, 10min
or 15min
MIC Gain (Internal)
MIC Gain (External)
Data Speed
1~3~4
1~2~4
4800bps or 9600bps
Sets the internal microphone sensi-
tivity to suit your preference.
Sets the external microphone sensi-
tivity to suit your preference.
Selects the data transmission speed
for low-speed communication, or be-
tween the [DATA] jack and external
modules like a GPS receiver, and so
on.
Turns the VOX function ON or OFF.
Sets the VOX gain level.
Sets the VOX Delay time.
Sets the VOX Time-Out Timer to pre-
vent an accidental prolonged trans-
mission.
Selects the headset type to be used
for the VOX function to limit the maxi-
mum audio output level to protect the
headset speaker.
(Continued on the next page.)
To Next Page
Loading...
