10
MENU SCREEN OPERATION
10
10-11
NOTE: The default settings, shown below, are for the USA version.
The default settings may differ, depending on the version.
Sets the beep output level.
Selects whether or not the beep output lev-
el can be adjusted by the [VOL] control.
Turns the confirmation beep tones when
key is pushed, ON or OFF.
Turns the scan stop beep ON or OFF.
Turns the standby beep function in the
DV mode ON or OFF.
Selects the audio output capability during
a sweep by the Band Scope function.
Selects if the time data is automatically
corrected by a received GPS sentence.
Sets the current date and time.
Enters the time difference between UTC
and the local time.
Turns the Auto power OFF function ON
or OFF.
Sounds
Beep Level
Beep/Vol Level Link
Key-Touch Beep
Scan Stop Beep
Scope AF Output
Standby Beep
0~3~9
In this item, set the Sound options.
OFF or ON
OFF or ON
OFF or ON
OFF or ON
OFF, ON or ON (to me:High Tone)
DESCRIPTIONSRANGE OR VALUE (Default is shown in bold)
Time Set
Date/Time
GPS Time Correct
UTC Offset
Auto Power OFF
In this item, set the Time options.
OFF or Auto
–14:00~±0:00~+14:00
OFF, 30min, 60min, 90min or 120min
DESCRIPTIONS
RANGE OR VALUE (Default is shown in bold)
SD Card*
2
Setting Load
Setting Save
File selection
<<New File>>
File selection
ALL, Except My Station,
Repeater List Only
In this item, set the microSD card options.
Format
SD Card Info
Unmount
DESCRIPTIONS
RANGE OR VALUE (Default is shown in bold)
Unmounts the card.
Formats the card.
Loads the settings file to the transceiv-
er.
Saves the settings as a new file.
Overwrites the settings to an existing
file.
Displays the free space and remaining
recording time of the card.
*
2
Be sure to insert the microSD card into the transceiver before selecting these items.
To Next Page
Loading...
