11
OTHER FUNCTIONS
11
11-13
!2 To display the File load screen, push D-pad() to
select the desired setting file, and then push D-
pad(Ent).
!3 Push D-pad() to select the desired loading con-
tent, as shown below.
• ALL: Loads all memory channels, item
settings in the menu list and the
repeater list into the transceiver.
• Except My Station: Loads all memory channels, item
settings in the menu list except
MY call signs and the repeater
list into the transceiver.
• Repeater List Only: Loads only the repeater list into
the transceiver.
!4 Push D-pad(Ent).
• The “Keep ‘SKIP’ setting in Repeater List?” appears.
!5 Push D-pad() to select “YES” or “No.”
• When “Yes” is selected, the skip setting (p. 4-32) of the
repeater list is retained.
!6 Push D-pad(Ent), “Load file?” appears.
!7 Push D-pad() to select “Yes,” then push D-pad(Ent)
to start the file check.
• While checking the le, “FILE CHECKING” and a prog-
ress bar are displayed.
!8 After checking, settings data loading starts.
• While loading, “LOADING” and a progress bar are dis-
played.
!9 After loading, “COMPLETED!” appears.
To complete the loaded, reboot the transceiver.
Reboot the transceiver to com-
plete the cloning/data loading.
Selecting the file which is
saved by the master trans-
ceiver.
Select “ALL” when all
memory channels, MENU
item settings and repeater
list to be copied.
Cloning function ■
Transceiver-to-Transceiver cloning using a microSD card (Continued) D
To Next Page
Loading...
