3
DR MODE <BASIC>
3-10
2. Receiving your own position data from the GPS
receiver
Hold down q for 1 second.
• The DR mode is selected.
Push D-pad( w ) to select “FROM,” and then push D-
pad(Ent).
Push D-pad( e ) to select “Near Repeater,” and then
push D-pad(Ent).
• The Repeater Search function starts. Up to 10 of the
nearest repeaters are displayed.
Push D-pad( r ) to select “Hirano430,” and then push
D-pad(Ent).
• “Hirano430” is displayed in “FROM.”
“FROM” (Access repeater) setting ■
“FROM” (Access repeater) setting using the Repeater Search function (Continued) D
Shows the distance
and direction from your
position to the repeater
Shows the call sign
of “Hirano430,”
“Hirano430” setting is completed.
NOTE: When the position data accuracy level is set
to “Approximate,” direction data is not displayed if
the distance to the repeater is under 5 kilometers.
NOTE:
When using the Repeater Search function, be sure to
first receive your own position data.
• If no repeater is found, screen 1, as shown to the
right, will be displayed.
• If the last used repeater can be used, the screen 2
as shown to the right will be displayed.
Screen 1 Screen 2
To Next Page
Loading...
