3
DR MODE <BASIC>
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
3-23
2. UR call sign setting
!2 Push D-pad(
) to select “UR,” and then push D-
pad(Ent).
!3 Push D-pad() to select the desired item, and then
push D-pad(Ent).
• CQCQCQ : Select to make a Local Area CQ call or
to a station by saying the station's call
sign.
• Gateway CQ : Select to make a Gateway CQ call. After
selecting “Gateway CQ,” select the des-
tination repeater in the repeater list.
• Your Call Sign : Select a station call sign in the Your Call
Sign memory to make a Local Area/
Gateway call.
• RX History : Select a station call sign in the RX Histo-
ry to make a Local Area/Gateway call.
• TX History : Select a station call sign in the TX Histo-
ry to make a Local Area/Gateway call.
3. R2 setting
!4 Push D-pad(
) to select “R2,” and then push D-
pad(Ent).
!5 Push D-pad() to select the desired item, and then
push D-pad(Ent).
• NOT USED* : “R2” setting is not used.
• GW : Select your gateway repeater.
• (Repeater) : Select the destination repeater to send a
call. (only for Zones)
4. MY call sign setting
!6 Push D-pad(
) to select “MY,” and then push D-
pad(Ent).
!7 Push D-pad() to select a desired MY Call sign,
and then push D-pad(Ent).
!8 Push [CLR] to set, and exit the CALL SIGN
screen.
Select
“UR” setting is completed.
Select
“R2” setting is completed.
Select
Select
“MY” setting is completed.
Settings are
completed
☞ Continued on the next page.
To Next Page
Loading...
