5
GPS/GPS-A OPERATION
5
5-11
GPS Memory longitude programming6.
#0 Push D-pad() to select “LONGITUDE.”
#1 Push D-pad(Ent), then the editing screen appears.
#2 Rotate [DIAL] to edit the longitude.
• The longitude between 0°00.00' to 180°00.00' are
programmable.
If "ddd° mm' ss"" is selected in POSITION FOR-
MAT screen, between 0°00'00" to 90°00'00" are
programmable.
(MENU > GPS > GPS Set > Position Format)
#3 Push D-pad() to move the cursor to left or right to
select and edit degrees or decimal minutes.
#4 Repeat steps #2 and #3 to enter a GPS Memory
longitude.
• Select “E” to program the east longitude, and “W”
when program the west longitude.
#5 After entering the longitude, push D-pad(Ent).
GPS Memory Bank programming7.
#6 Push D-pad() to select “BANK.”
#7 Push D-pad(Ent), then the editing screen appears.
#8 Push D-pad() to select a bank between A to Z, or
select “OFF” and push D-pad(Ent).
• Each bank is capable of storing up to 100 GPS
memories.
#9 After selecting the GPS Memory bank, push D-
pad(Ent).
Writing GPS Memory8.
$0 Push D-pad() to select “<<Add Write>>,” and then
push D-pad(Ent).
• If a previously added GPS memory is edited, select
“<<Overwrite>>.”
$1 Push D-pad() to select “YES,” and then push D-
pad(Ent).
(Example)
When “HOUSE”
is saved in
bank A.
Bank screen
GPS Memory
channel list
Select
Added to the
GPS Memory
channel list
“00:.”
To cancel the programmed data:
To cancel the programmed data, push [CLR] q
to display “Cancel edit?.”
Push D-pad( w
) to select “YES,” and then push D-
pad(Ent) to cancel pro-
gramming and return
to the GPS Memory’s
channel list screen.
To Next Page
Loading...
