IDEC MICRO/I HG1P-ST32 Series User Manual

Preface-21 WindO/I-NV4 User’s Manual
4.6 Operating E-mail function and checking sending status .................................. 28-42
4.7 Restrictions of each E-mail ........................................................................... 28-43
4.8 E-mail Function Configuration Procedure.......................................................28-44
4.9 E-mail Settings Dialog Box ........................................................................... 28-54
Chapter 29 Data Transfer Function
1 Project Transfer Function......................................................................................29-1
1.1 What Can Be Done with the Project Transfer Function......................................29-1
1.2 Project Transfer Procedures............................................................................29-2
1.3 Converting Project for Transfer .......................................................................29-3
1.4 Using Key Buttons, Multi-Buttons, or Multi-Commands to Transfer Project Data
....................................................................................................................29-6
1.5 Using File Manager on the MICRO/I to Transfer Project Data ............................29-7
1.6 Precautions.................................................................................................29-15
2 PLC Program Transfer Function ........................................................................... 29-16
2.1 Supported PLCs...........................................................................................29-16
2.2 What Can Be Done using the PLC Program Transfer Function.......................... 29-17
2.3 PLC Program Transfer Procedures ................................................................. 29-17
2.4 Creating ZLD Project File..............................................................................29-18
2.5 Using Key Buttons, Multi-Buttons, or Multi-Commands to Transfer PLC Programs
.................................................................................................................. 29-19
2.6 Using File Manager on the MICRO/I to Transfer PLC Programs........................ 29-21
2.7 Precautions.................................................................................................29-29
3 File Copy Function ............................................................................................. 29-30
3.1 What Can Be Done with the File Copy Function ............................................. 29-30
3.2 File Copy Operating Procedures.................................................................... 29-31
3.3 Using Key Buttons, Multi-Buttons, or Multi-Commands to Copy Files................29-32
3.4 Using File Manager on the MICRO/I to Transfer Project Data ..........................29-33
3.5 Precautions.................................................................................................29-38
Chapter 30 Expansion Modules
1 Overview ............................................................................................................30-1
1.1 Overview of Expansion Modules .....................................................................30-1
1.2 Applicable Expansion Modules ........................................................................30-2
1.3 The Expansion Module Operation ...................................................................30-6
2 Digital I/O Modules............................................................................................ 30-12
2.1 Using Digital I/O Modules ............................................................................ 30-12
3 Analog I/O Modules ........................................................................................... 30-13
3.1 Using Analog I/O Modules............................................................................ 30-13
3.2 Analog I/O Module Parameter Settings..........................................................30-14
3.3 Device Allocation.........................................................................................30-24
4 Cyclic Script ...................................................................................................... 30-28
4.1 Setting Procedures for Cyclic Script............................................................... 30-28
5 Module Configuration Dialog Box ........................................................................ 30-29
5.1 Overview .................................................................................................... 30-29
5.2 Basic Operations for Module Configuration Dialog Box.................................... 30-30

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English