112
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
Telephone Remote Control.
Some sytems may utilize the “DTMF Control” option to allow the system to be controlled
by any telephone able to send DTMF tones. i.e. Any touch tone phone. By dialing the
system and using the telephone keypad, pre-defined Areas and Auxiliary outputs can be
turned On and/or Off with different 4 digit codes. (Only available V3 or later)
Consult your installer for the “Phone number”, “Control Mode” tone and “Control
Codes”. These may be recorded on the following page, but should be kept secure.
OPERATION
1. Dial the system from the telephone.
2. When the system answers the phone, you have 5 seconds to send the “Control
Mode” tone to put the system into DTMF Control mode.
i.e. Press the single digit on the telephone keypad that represents the”Control
Mode” tone. (You do not need to wait for any prompt)
3. Wait for the system to send back the “Start Tone” (3 short beeps).
4. When you hear the “Start Tone” you then have 10 seconds to start entering a 4
digit “Control Code” to perform the required action. Each digit of the Control
Code must be entered within 10 seconds of the previous digit.
5. The system will send back an acknowledgement tone to indicate a successful
“On” (1 beep) / “Off” (2 beeps) action or “Error” (1 long lower pitch beep).
See the table on the following page for details of Acknowledgement tones.
6. After the acknowledgement tone, a new Control Code may be entered or enter
“0000” to command the system to hang-up.
NOTES:
-If you make an error entering a Control Code, press <*> or <#>, wait for the “Start
Tone” and start again.
-An “On” tone is sent back if you attempt to turn On an item that is already On.
-An “Off” tone is sent back if you attempt to turn Off an item that is already Off.
-For Security reasons, the system will hang-up if any of the following occurs:
-The 10 second digit timer expires while waiting for Control Code digits.
-A Valid Control Code is not entered after 6 successive tries.
-A Valid Control Code is not entered within 60 seconds.
To Next Page
Loading...
Need help?
General