Inner Range Concept 4000 - ] Activating a Duress Alarm

23
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
Activating a “Duress” Alarm.
Your system may be programmed to allow a Duress alarm to be activated if you are
being forced to perform operations at an LCD Terminal against your will.
Duress is activated by simply entering a special PIN Code instead of your normal PIN
Code, when logging on to the LCD Terminal.
See “LOGON to an LCD Terminal”.
The resulting action will depend on how the system is programmed.
Typically a “Silent” alarm is activated. (A discreet alarm report is sent to the remote
monitoring station)
IMPORTANT NOTE: Consult your Installer:
- To detemine if the Duress Code function is enabled in your system.
- For details of any Duress Codes that will be used.
- For details of how the Duress Code function will operate &/or report.
You may wish to use the space below to record the details of how your Duress Code
system will operate. (NOTE: The Duress PIN Codes should not be recorded here)
Duress Code processing enabled: (Circle) YES / NO
Method Used: -Special PIN Code/s [ ]
-Add 1 to last digit of PIN [ ]
On-Site action (If any).......................................................................
...........................................................................................................
...........................................................................................................
Monitoring / Reporting action. ..........................................................
...........................................................................................................
...........................................................................................................
Panic/Duress