Inner Range Concept 4000 User Manual

18
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
Turning Area/s ON.
Logon to the Terminal as described earlier.
(PIN code + <OK>)
After the greeting (if enabled), the display will show
the Area Status etc. as before. If you are allowed to
control more than one Area, the DISPLAY MODE
can be changed and AREA/S SELECTED as
described in “Turning Area/s OFF”.
At the “Push ON” prompt, turn the displayed Area
(or Area List) ON by pressing the <ON> key.
After the <ON> key is pressed, the system will test
the state of all the inputs allocated to the Area to
ensure that they are in the Sealed condition and the
Area is ready to be turned ON.
THEN:
If all Zones programmed to be tested are Sealed, the
Area will turn ON and this display will indicate that
the operation was successful.
While this message is displayed, you can press the
<ON> key again to view the Exit delay time counting
down in 5 second increments.
Remember: You have a limited time to exit the Area
once you have turned it ON. (Usually 30-90 seconds.
Ask the Installer for the time used in your system)
When the operation is complete the display will
return to the Area status message.


















Display briefly shows:






Display briefly shows:
then:
- ,
IMPORTANT NOTE: Some systems in high security applications may have the Pre-
Arm “Walk Test” feature enabled. (V3 or later only). In most systems this feature is
not enabled and the Area ON procedure will simply be performed as described below.
If Walk Testing is enabled on your system, the same procedure is followed except
that after the initial test to ensure that all Zones are Sealed, the system then enters
Walk Test mode. Refer to “Area Walk Testing” on the following page.






See “Quick Arm/Disarm” under “Turning Area/s OFF” for additional information.

Inner Range Concept 4000 Specifications

General

Brand	Inner Range
Model	Concept 4000
Category	Touch terminals
Language	English