Inner Range Concept 4000 User Manual

16
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.






Turning Area/s OFF.
Logon to the Terminal as described earlier.
(PIN code + <OK>)
After the greeting (if enabled), the display will show
the Area Status etc. as before. To select another Area
see “AREA SELECTION” on the next page.
At the “Push OFF” prompt, turn the displayed Area
(or Area List) OFF by pressing the <OFF> key.
The display will alter accordingly to indicate that
the operation was successful.
If you are allowed to control more than one
Area:
-DISPLAY MODE.
The Display mode can be changed from Single
AREA to AREA LIST and vice versa, by pressing
the <RIGHT ARROW> key.
By using AREA LISTS, you can turn OFF all the
Areas in the List that you are allowed to control,
with a single operation.
i.e. You can select any Area List in the system.
However, only Areas that are in the Area List selected
and are also in the Area List in your “User Type”,
or your “Extra Area” will be turned Off.
Once you have Logged on to a Terminal, and have seen the Area status with the “Push
Off” or “Push On” message, you may perform the Area OFF or ON operations.
Remember: You have a limited time to turn an Area OFF once you have entered the
Area (Usually 30-90 seconds). Ask the Installer for the Entry time used in your system.












- ,
NOTE: Quick Arm/Disarm. Your system may be configured to allow a nominated
Area to be controlled simply by entering your PIN code, then the OFF or ON key.
i.e. OK key not required. (V7.8 or later only with LCD Terminal V8.3 or later)

Inner Range Concept 4000 Specifications

General

Brand	Inner Range
Model	Concept 4000
Category	Touch terminals
Language	English