Inner Range Concept 4000 - Select User Codes; Select a User to Program;Edit; User Name

48
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
SELECT “USER CODES”.
SELECT A USER TO PROGRAM/EDIT.
The display will first allow you to choose a User
number to alter. (Method i)
Pressing the <ON> key will allow an existing User
to be selected by name.
(Alpha-search - Method ii)
In either mode, the <UP> and <DOWN> Arrows
will search through the User numbers/names.
i) <DIGIT> keys are used to enter a User number,
OR
ii) When searching for a particular User name, press
the <DIGIT> key that represents the first letter of
the name. (You may have to press the key 2 or 3
times to obtain the required letter.)
If the User you want is not displayed because of
other names starting with the same letter, use the
<DOWN> Arrow key to locate the User’s name.
When the desired User number or name is located,
press the <OK> key to proceed with editing.
NOTE: Use the <END> key at any time to save the
current setting and Exit User programming.
USER NAME.
The display will show the User number and name.
To enter a new name press the <OFF> key to clear
the screen, then use the <DIGIT> keys to program
the name. Up to 16 characters of text can be entered.
To modify an existing name, use the <LEFT> and
<RIGHT> Arrow keys to position the cursor under
the letter to be changed, and then use a <DIGIT>
key to enter the new letter.












      
      
   



    
    
  



, - - -