70
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
, , ...
USER TYPE TENANCY (V6.2 or later only)
The display shows the current Tenancy allocated.
If a User has the ability to Program/Edit Users,
they can normally assign any User Type.
When a User has a Tenancy programmed, they can
only assign User Types that have a matching
Tenancy number. See USER TENANCY in the
section “USER CODE PROGRAMMING”.
To assign a Tenancy number, press the <OFF> key
to clear the screen then enter the desired Tenancy
number from 001 to 255 with the <DIGIT> keys.
<OK> for next option. <UP>/<DOWN> key to
edit this option for the previous/next User Type.
ASSIGN A VALID AUXILIARY
This display allows an optional Auxiliary output
to be specified that will turn ON whenever this
User Type uses their PIN number or Card.
Use the <DIGIT> keys to enter an Auxiliary ID.
(The <RIGHT> arrow key will need to be used
after the Module type letter is entered.)
Press <OFF> to remove an existing Auxiliary ID.
HOME AUXILIARY TYPES TO CONTROL.
The display will show the existing Home
Auxiliary Types allowed.
When Home Auxiliaries are turned ON/OFF via
the “Control Menu” (<MENU> 9 , 1.), the User
Type can only control Home Auxiliaries that have
a matching Home Auxiliary Type set to YES.
Use the <RIGHT> Arrow key, followed by the
<9> (Yes) key to assign the required Rank/s. Use
the <5> (No) key to remove a Rank setting.
<OK> key for next User Type to edit.
<UP> / <DOWN> key to edit this option for the
previous/next User Type.
NOTE: If “Tenancy” is not
used in the system, all Tenancy
settings must be left at “000”.
or or
, or
or or
- - -
To Next Page
Loading...