To Next Page

To Previous Page

CONCEPT 4000.CONCEPT 4000.

CONCEPT 4000. User Manual.

Testing: Menu Option 4

Testing simply involves activating the devices (usually detectors) and then allowing

them to return to their normal state. e.g. Walk past movement detectors, open and

close doors, press then release panic buttons, etc.

The system can perform automatic testing on devices that are regularly activated by

movement, etc., such as PIRs and Door Contacts. However, other types of Input

devices, such as Glass-break, Smoke & Seismic detectors, Panic buttons, Window

Contacts, etc. should also be tested on a regular basis. (e.g. Once every month)

NOTE: The additional Test Menu options shown in the Menu Flowchart at the rear of

this manual are only accessible to the Installer. They provide a comprehensive range

of Testing to assist with installation, commissioning and service of the system.

The display will prompt you to select an Area to

Test.

The <UP> and <DOWN> Arrows will search

through the Area names alphabetically,

Press the <DIGIT> key that represents the first letter

of the name. (You may have to press the key 2 or 3

times to obtain the required letter.)

If the name you want is not displayed because of

other names starting with the same letter, use the

<DOWN> Arrow key to locate the name.

When the Area is selected, press the <OK> key to

proceed.

If the maximum time allowed for Walk Testing

expires, the test will be aborted and the display will

return to the “Area to Test?” prompt.

The maximum test time is programmed by the

Installer for each Area. If the max. test time for an

Area is set to zero, the maximum test time will then

be 10 minutes.









then if required.

Your system may be programmed with an option

to allow Walk testing of specified Zones in

particular Areas. (V3 or later only)

Inner Range Concept 4000 User Manual

Other manuals for Inner Range Concept 4000