Inner Range Concept 4000 User Manual

85
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
NOTE: For comprehensive testing of the system, including the reporting
facilities, a procedure similar to the following is used on appropriate sites:
Arrange with the Central Monitoring Station for testing to be performed periodically
in “real-life” conditions. This involves setting aside a period when all Areas in the
system are turned ON, then activating all the Input Devices. A report from the
Central Station is then used to check that all devices activated were reported.
This method also tests that Input processing and Reporting options have been
programmed appropriately, and that the alarm reporting is occuring effectively.






After an initial test to check that all Zones are Sealed,
the Walk Test commences. The display will update
every few seconds with a beep to show each Zone
that has not been tested.
The following key functions are available while this
display is shown, and may need to be used if any
device fails to operate or cannot be tested:
To manually advance to the next untested Zone, press
the <DOWN> arrow key.
To abort the Walk Test because a Zone is faulty and
cannot be tested, press the <OK> key.
A “Test Failed” message will be displayed.
Press the <OK> key again to return to the “Area to
Test?” prompt.
To abort the Walk Test, press the <END> key.
The display will briefly show “Operation Aborted”,
then return to the “Area to Test?” prompt.
When all the Zones have been tested and there are
no faults, the “Test Passed” message is displayed.
Push <OK> to exit the Walk Test mode and select
another Area to Test.
Select another Area to test or Press the <END> key
to exit and return to the normal display.












ZONE TEST

Inner Range Concept 4000 Specifications

General

Brand	Inner Range
Model	Concept 4000
Category	Touch terminals
Language	English