17
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
Area On/Off
- , ,
or
Deferred Arming option.
In some applications the system is programmed so that certain User types may only turn
the Area Off for a limited time. e.g. A cleaner or guard working outside normal working
hours may only turn the Area Off for 60 minute intervals. (V2 or later only)
When these User types turn the Area Off, the display
shows Area is Off with a “Defer timer” running.
At any stage during the defer time, the User can turn
the Area Off again, to re-start the timer, (V3 or later
only) or turn the Area back On and cancel the timer.
When the timer has only 250 seconds left to run, the
LCD Terminal will beep every 2 seconds and display
this warning.
The User can still perform the Area Off or Area On
operations during this warning period, but if no
action is taken the Area will automatically turn On
when the warning period expires.
NOTE: If more than one Area is about to turn On,
the display shows each Area in turn for 2 seconds.
-AREA / AREA LIST SELECTION.
You may select other Areas or Area Lists by using
the <UP> and <DOWN> Arrow keys and/or the
<DIGIT> keys to select the 1st letter that the Area
name begins with.
e.g. A system has Areas named “Reception”, “R &
D” and “Rodneys Office”.
1) To select any of these Areas, press the <6 PQR>
key until an Area starting with “R” is displayed.
(You may need to press the key between 1 and 3
times depending on other Area names in the system)
2) If the Area that you require is not displayed, use
the <DOWN> Arrow key to scroll through, and
select, the other Areas starting with that letter.
Note: Areas are sorted numerically after the 1st letter.
To Next Page
Loading...
Need help?
General