56
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
[N]o message acknowledgement. Prevent the User from being given the option to
acknowledge alarm messages when logged on to a
Terminal.
[D]uress Code. Causes the PIN code programmed for this User to
trigger a Duress Input whenever it is entered.
IMPORTANT NOTE: If this option is set to Yes, DO NOT use any words in the
User’s name (e.g. Duress, Holdup, etc.) that indicate that a Duress Code is being used,
as the name may be displayed in the greeting when the User logs on to the Terminal.
Area [L]ist default. Allows the “Area List” selection screen to appear
on the display when this User logs on to the
Terminal (rather than individual Area selection).
The User can still revert to selection of an
individual Area, if required, by pressing the
<RIGHT> arrow key. See “Turning Area/s Off”.
[E]xtra Area Off Allows the User’s “Extra Area” (if assigned) to be
turned Off when the User accesses a Door via a
Reader that allows the “Turn off Extra Area”
function. (If enabled by the Installer)
(V2 or later only)
No [G]reeting Disables the User greeting from being displayed
for this User, when logging on to an LCD
Terminal. (V3 or later only)
or or
USER OPTIONS
There are currently five special options which may
be set for a User.
Use the <RIGHT> Arrow, followed by the <9>
(Y) & <5> (N) keys to set the desired options to
YES or NO.
When complete: <OK> key to move on to the
next question for this User.
<UP> key to edit the previous User’s “Options”.
<DOWN Arrow to edit the next User’s “Options”.
, or
To Next Page
Loading...
Need help?
General