59
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
RF FOB OPTIONS
If a Wireless Remote Fob has been registered to this User, these options may be used
to program the operation of the button/s available on the Fob.
See “RF Fob Registration”. MENU, 2, 7.
COMPATIBLE FOBS
Paradox Wireless RF Fobs. (Available in Concept 3000/4000 Firmware Version
V7.6 or later)
4-button Wireless remote (REM1)
5-button Wireless remote (REM2)
15-button Wireless remote (REM3)
REM3 provides 2 sets of ARM/OFF buttons and optional PIN code verification.
Visonic Wireless RF Fobs. (Available in Concept 3000/4000 Firmware Version
V5.1 or later)
4-button Wireless remote (MCT-234 / MCT-234W).
1-button Wireless remote (MCT-231 / MCT-231WP)
(NOTE: The single-button Fob action is programmed via the Button 2 options)
IMPORTANT NOTES:
1) At least one of the appropriate type of RF Expander Module must be installed in
the system in order to utilize Wireless Remote Fobs.
2) Consult the Installer to determine the Fob operations available in your system.
3) These User programming options are only available to the “Installer” (U00001)
& “Master” (U00002) Users.
4) If PIN codes are to be used with Paradox REM3 Remotes, the User’s PIN code
must be either 4 or 6 digits in length, and the “6 digit PIN codes” Fob option
programmed accordingly.
5) See “Wireless Remote Fob Operations” for User instructions and User feedback
indications, and to record the Fob button operations.
6) Area or Auxiliary Fob operations are only allowed if the “F” option (Allow Fob)
is set to Yes in the “.FdDUAPC” screen in the User’s “User Type”.
USER EDIT
To Next Page
Loading...
Need help?
General