21
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
Turning 24 Hour (Tamper) monitoring OFF and ON.
Logon to the Terminal as described earlier.
(PIN code + <OK>)
After the greeting, the display will show the Area
Status etc. as before.
Press the <LEFT ARROW> key to change the
display mode to show the status of the 24Hr (or
Tamper) part of the Area.
The display will now show the Area name and
indicate if 24Hr (Tamper) monitoring is Off or On
in this Area.
Use the <OFF> or <ON> key to turn the 24Hr
(Tamper) monitoring Off or On as required.
The display will alter accordingly to indicate that
the operation was successful.
If you need to turn 24Hr monitoring Off in
other Areas:
You may select other Areas by using the <UP> and
<DOWN> Arrow keys or the letter key that the Area
name begins with.
The 24Hr part of an Area continuously monitors the equipment and inputs for faults or
deliberate interference and activates “Tamper” alarms when these conditions occur.
Occasionally the Installer, or a User with the appropriate level of authority, may need to
turn the 24Hr part of an Area Off so that maintenance or changes can be performed on
equipment or devices (detectors etc.) in the system.
Note that most Users in the system will NOT have access to this operation.
- ,
or
Area On/Off
NOTES: When the 24Hr monitoring is turned Off in an Area, it will automatically be
turned back On again when the Area is turned ON to ensure that Tamper monitoring is
not compromised. If the Area was already Off when the 24Hr monitoring was turned
Off, the Area must be turned back on again before 24Hr monitoring will be re-enabled.
To Next Page
Loading...
Need help?
General