117
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
System Control via Short Message Service (SMS)
The following information must be provided to the installer to enable the feature to
operate as required:
1. The type/s of commands that will be allowed via the GSM Short Message Service.
e.g. Area control / Home Auxiliary Control / Zone Isolate & Restore / List Status.
2. For security reasons it is recommended that a PIN code is entered before the
command text. Inform the installer whether you require this feature or not.
(If you do not wish to use a PIN code, step 3 MUST be used)
3. Control can be limited to just one or two Mobile phones. If this is desired provide
the installer with the phone number/s of the nominated Mobile phone/s.
Before you can use this feature:
1. Check that Short Message Service is enabled on your GSM Mobile Service.
2. Check that the “Message Centre Number” is programmed in your Mobile phone.
3. Check that your Mobile phone is programmed to send messages as “Text”.
4. For ease of use you may enter the system’s GSM Modem phone number as a pre-
programmed number in your Mobile phone.
Send an SMS command:
(Actual procedure for sending SMS messages may differ depending on make and
model of Mobile phone. See your Mobile phone’s User Manual for details)
1. Using your GSM Mobile phone, enter the Text command that you wish to perform
according to the tables on the next page and select “Send”.
If a PIN code is required, enter the PIN code immediately before the text
command. See examples in the tables on the following pages.
2. Enter or Select the system’s mobile phone number and send the message.
3. Wait for the system to send back the text message or confirmation.
See the “SMS CONFIRMATION AND INFORMATION MESSAGES” table on
the following pages.
NOTES:
1. Any PIN code used for SMS commands MUST be a PIN code programmed for a
User between User 00001 and User 00032 and any Areas or Home Auxiliaries to
be controlled must be allowed in that User’s “User Type”.
2. Most GSM Mobile phone manufacturers also produce Data Suite software that
interfaces a PC to a GSM Mobile phone and provides the ability to send and
receive messages via the Short Message Service from a PC.
GSM / SMS
To Next Page
Loading...
Need help?
General