User’s Manual INNOMAR Parametric Sub-Bottom Profilers / SESWIN 121
Innomar Technologie GmbH (2023-01) 121
This message is shown by the INNOMAR “compact” model, if no Ethernet cable is plugged to the
control computer.
“NetControl failed to connect.”
This message is shown by the INNOMAR “smart” and “compact” models, if no Ethernet connection
could be established between the control computer and the topside unit.
8.4 SESWIN Error and Warning Messages at System Setup
During system setup (menu “System Setup – Settings”) some error or warning messages my
show up as below.
“Switch transmitting Mode to Sub-Bottom Single Frequency ...”
“Multi-Ping” and “Burst” modes are possible with “internal trigger” only. If synchronisation is set
to “external trigger” or “alternating trigger” these system modes are not available.
“xxx Port was not opened ...”
This warning message shows up if settings of one of the serial I/O ports (Navigation Input, Multi
Input or Depth Output) are changed, but the related port could not be opened at system start-up.
“The length of one or more SIS Strings is set to zero. Please check your settings.”
This warning message shows up if at least one of the SIS strings is set to length “0”. This means
that at this position no information is stored. See sections 5.11.8 (page 64) and 7.3 (page 92) for
details.
“PC-Time Synchronisation is not available. Please turn off User Account Control (UAC) or
run SESWIN as Administrator ...”
The SESWIN function to synchronize the PC clock to the GNSS time needs Windows permission
to access the PC clock. This permission is by default given to the administrator only. Therefore,
you have either to run SESWIN with administrator privileges or to change the settings at “Control
Panel -> All Control Panel Items -> User Accounts -> Change User Account Control Settings”.
After changing this to “never notify”, please re-boot Windows.
“Input and Output positions are the same. Are you sure?”
If you set up the “Coordinate Conversion” (see section 5.11.11 on page 67) this message warns
you when source and destination SIS string ID is the same, because in this case the original
GNSS position data is lost. You should keep the original position data and write the converted
data to another SIS string.
“Determining Failed”
This is shown if the local UTM zone could not be determined from the current GNSS position
data. See section 5.11.11 on page 67.
“Offset Correction was turned on. The applied Motion Sensor Format is TSS-1. This format
does not include true heading information. Please configure settings ...”
To Next Page
Loading...