innomar SBP smart - Innomar Training Courses

16 User’s Manual INNOMAR Parametric Sub-Bottom Profilers / SESWIN
16 Innomar Technologie GmbH (2023-01)
1.5 Innomar Training Courses
We strongly recommend to all users and technicians working with INNOMAR SBPs to attend the
Innomar training courses as appropriate. INNOMAR offers the following courses:
Operators Processors Technicians
TR1 (max. 8 hours) TR2 (max. 8 hours) TR4 (max. 4 hours)
Basics
 underwater acoustics
 sub-bottom profiling
 parametric acoustics
 Innomar SBP models
Installation
 transducer mounting
 topside installation
 interfaces
 noise & interference
 software
Operation (SESWIN)
 typical settings
 data formats
2D Data Processing
(SesConvert, ISE)
 data formats
 data conversion
(SesConvert)
 ISE data (pre-)
processing
 quality assurance
 reflectors & targets
 data export
Maintenance and
trouble-shooting
 Innomar SBP models
 system components
 system installation
 system check
 basic maintenance
 repairs (board
replacement)
 special test tools and
equipment (STE)
TR3 (max. 8 hours)
3D Data Processing
(“quattro” / ”sixpack”)
 processing workflow
 data gridding
 volume rendering
 visualisation
Also available with boat
“hands on” training (TR5)
Note: TR3 requires TR2 Note: TR1 recommended
Please contact INNOMAR for more information and for customized training courses. Training is
available at the INNOMAR main office in Germany (max. 10 attendees) or on-site or as online
courses.