178 User’s Manual INNOMAR Parametric Sub-Bottom Profilers / SESWIN
178 Innomar Technologie GmbH (2023-01)
Subsea Unit
Dimensions (D×L) 278 mm x 743 mm
Weight in air / water c. 58 kg / c. 15 kg
Material / Depth Rating Titanium Grade 5 / 200 bar (2,000 m)
The control- and data acquisition PC is connected via Ethernet. There
is no data stored within the subsea unit.
Water sensor
(pointing up)
Interface
connector
Pressure valve
Zinc anode
Transducer
connector
Interface Connector (Power, Ethernet, Motion Sensor, Trigger)
Burton 5506-2013 13 pins male connector on pressure pod. Please use Burton 5501-2013-E0xx pigtail
with twisted-pair Ethernet connection.
Pin 1 X Power L (+)
Pin 2 X Motion sensor RX data (RS232)
Pin 3 X Motion sensor GND (RS232)
Pin 4 X Power N (GND)
Pin 5 X Ethernet TX+ RJ45 pin#1 orange/white
Pin 6 X Ethernet TX- RJ45 pin#2 orange
Pin 7 X Chassis Ground (Screen)
Pin 8 X Ethernet RX+ RJ45 pin#3 green/white
Pin 9 X Ethernet RX- RJ45 pin#6 green
Pin 10 Trigger OUT (RS232 levels)
Pin 11 Trigger IN (RS232 levels)
Pin 12 GND Trigger IN
Pin 13 GND Trigger OUT
X required connection
Deck Test Cable
Innomar does not provide the cable needed for interfacing to the vehicle, this cable depends on
the connectors at the vehicle itself and should be prepared specifically for the vehicle used.
For system test purposes Innomar provides a deck test cable (not water proof), only.
Interface connector (Burton 13-pin)
Power (100 – 240 V AC)
Ethernet connector (RJ45)
Motion data input (RS232 DB9)
Trigger in/out (BNC)
To Next Page