EasyManua.ls Logo

Juniper BGP - CONFIGURATION GUIDE V 11.1.X - Page 215

Juniper BGP - CONFIGURATION GUIDE V 11.1.X
748 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Negotiated hold timeNegotiated maximum time allowed between received
messages
Configured update source IP addressIP address used when sending update
messages
Local IP addressLocal IP address used for TCP communication to this peer
Local portLocal TCP port number used for TCP communication to this peer
Remote IP addressRemote IP address used for TCP communication to this
peer
Remote portRemote IP address used for TCP communication to this peer
Total messages sentTotal BGP messages sent to this neighbor
Total messages receivedTotal BGP messages received from this neighbor
Total update messages sentTotal BGP update messages sent to this neighbor
Total update messages receivedTotal BGP update messages received from
this neighbor
Time since last update message was receivedTime since last BGP update
message was received from this neighbor
Address Family dependent capabilitiesLists type of ORF send and receive
capability per address family and whether it is advertised (configured) or
received
Maximum number of ORF entriesLimit of ORF entries that will be accepted
from the neighbor
Capability advertisementLists whether the specific capability (capabilities
option, deprecated dynamic capability negotiation, dynamic capability
negotiation, multiprotocol extensions, route refresh, route refresh (Cisco
proprietary), four octet AS numbers, and graceful restart) has been sent,
received, or both
Multi-protocol extensions negotiationLists the relevant address family and
whether it has been sent, received, or used
BFDStatus of BFD configuration, enabled, enabled but not supported
because the peer is an IBGP neighbor a multihop EBGP neighbor, or disabled
BFD sessionType and address of peer to which BFD session is established
Minimum transmit intervalDesired interval between BFD packets
transmitted to members of peer group
Minimum receive intervalDesired interval between BFD packets received
from members of peer group
MultiplierNumber of BFD packets that can be missed before declaring BFD
session down
Monitoring BGP 179
Chapter 1: Configuring BGP Routing

Table of Contents

Related product manuals