active at a given time, this command does not give a complete picture of the
configuration.
■ Use the member-circuits keyword to display circuit information for the group.
■ Field descriptions
■ routed to/base LSP—Identifies address of the router at the other end of the
tunnel and the base tunnel that is selected to forward the traffic
■ load-balancing group—Group number
■ Martini group-id—Martini group ID number for the interface
■ state—State of the interface
■ vc-id—VC ID number for the interface
■ mtu—Maximum transmission unit for the interface
■ In label—Label sent to upstream neighbor for route; statistics below this field
are the aggregate statistics for traffic from the core
■ Out label—Label received from downstream neighbor for route; statistics
below this field are the aggregate statistics for traffic to the core
■ pkts—Number of packets sent across tunnel
■ hcPkts—Number of high-capacity (64-bit) packets sent across tunnel
■ octets—Number of octets sent across tunnel
■ hcOctets—Number of high-capacity (64-bit) octets sent across tunnel
■ errors—Number of packets dropped for some reason before being sent
■ queue 0—Number of the queue for which statistics are being displayed and
whether the queue is under traffic class control
■ traffic class—Name of traffic class
■ bound to—Interface to which queue is bound
■ Queue length—Size of queue in length and bytes
■ Forwarded—Number of forwarded packets and bytes
■ Dropped committed—Number of committed packets and bytes dropped
■ Dropped conformed—Number of conformed packets and bytes dropped
■ Dropped exceeded—Number of exceeded packets and bytes dropped
■ discardPkts—Number of packets discarded due to lack of buffer space before
being sent
■ Member Interfaces—Information about the member interfaces for the circuit
502 ■ Monitoring BGP/MPLS VPNs
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...