■ Interface—Interface specifier and status; active indicates it is being used for
traffic from the core; if active is not displayed, interface is not currently being
used for traffic, but the statistics may be valid
■ member ports—Number and type of candidate ports configured for the
group, including interface specifiers and state
■ member circuits—Number of member circuits configured for each port and
for the group
■ Example 1
host1#show mpls l2transport load-balancing-group 100 member-circuits
routed to 10.9.1.3 on base LSP tun mpls:lsp-de090103-32-3e
load-balancing-group 100
Martini group-id 2 vc-id 200002 mtu 1500
State UP
In Label 57 on stack
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Out Label 59 on tun mpls:lsp-de090103-32-3e
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
queue 0: traffic class best-effort, bound to atm-vc ATM6/0.1
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
Member Interfaces
Interface fastEthernet 2/0.2 active
Incoming Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Outgoing Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Interface fastEthernet 3/0.2
Incoming Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Outgoing Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
■ Example 2
host1#show mpls l2transport load-balancing-group member-circuits brief
4 member ports:
fastEthernet 2/0 down
fastEthernet 3/0 30 member circuits
fastEthernet 4/0 30 member circuits
fastEthernet 5/0 30 member circuits
90 member circuits
■ See show mpls l2transport load-balancing-group.
Monitoring BGP/MPLS VPNs ■ 503
Chapter 5: Configuring BGP-MPLS Applications
To Next Page
Loading...