!
controller t3 4/0
no shutdown
clock source internal module
cablelength 5
t1 1 clock source internal module
t1 1/1 timeslots 1-24 speed 64
t1 2 clock source internal module
t1 2/1 timeslots 1-24 speed 64
!
controller t3 4/1
no shutdown
clock source internal module
cablelength 5
t1 1 clock source internal module
t1 1/1 timeslots 1-24 speed 64
t1 2 clock source internal module
t1 2/1 timeslots 1-24 speed 64
!--------------------------------------------------------------------------
!Create virtual router default.
!--------------------------------------------------------------------------
virtual-router default
interface loopback 0
ip address 222.9.1.1 255.255.255.255
!--------------------------------------------------------------------------
!Configure Frame Relay interfaces.
!--------------------------------------------------------------------------
interface serial 4/0:1/1
encapsulation frame-relay ietf
interface serial 4/0:1/1.1
frame-relay interface-dlci 17 ietf
!
interface serial 4/0:2/1
encapsulation frame-relay ietf
interface serial 4/0:2/1.1
frame-relay interface-dlci 12 ietf
!
interface serial 4/1:1/1
encapsulation frame-relay ietf
frame-relay intf-type dce
interface serial 4/1:1/1.1
frame-relay interface-dlci 17 ietf
!
interface serial 4/1:2/1
encapsulation frame-relay ietf
frame-relay intf-type dce
interface serial 4/1:2/1.1
frame-relay interface-dlci 12 ietf
!--------------------------------------------------------------------------
!Create virtual router two. Configure MPLS.
!--------------------------------------------------------------------------
virtual-router two
mpls
mpls ldp tar send list 222.9.1.3
interface loopback 0
ip address 222.9.1.2 255.255.255.255
ip router isis
interface atm 2/0
Frame Relay over MPLS Configuration Example â– 545
Chapter 7: Configuring Layer 2 Services over MPLS
To Next Page
Loading...
Need help?
General
