Manitowoc MLC650 User Manual

OPERATING CONTROLS AND PROCEDURES MLC650 OPERATOR MANUAL
3-44
Published 08-12-19, Control # 224-13
10
Upperworks Jack Storage
Cylinders, Left
The function light (9) glows GREEN next to the icon for the setup function that
has been selected.
11
Upperworks Jack Storage
Cylinders, Right
12
Upperworks Jacks: ALL jacks
operated at the same time.
13
Upperworks Jacks: Individual
jack can be operated.
14 Rigging Winch
15
Carbody Jacks: ALL jacks
operated at the same time.
16
Carbody Jacks: Individual jack
can be operated.
17 Rotating Bed Pins, Front
18 Rotating Bed Pins, Rear
19 Live Mast Assist Arms
20 Crawler Pins, Left
21 Crawler Pins, Right
22 Counterweight Tray, In/Out
23 VPC-MAX Pins
24 VPC-MAX Beam Travel, In/Out
25 VPC-MAX Beam Pins, Upper
26 VPC-MAX Beam Pins, Lower
27 Selector Switch
Move this switch UP or DOWN to scroll through the set up functions (10 through
25) until the green light appears next to the desired function.
28 Communication Light
Flashes GREEN to indicate that there is a good signal between the transceiver
and the remote control. If the signal is lost, troubleshoot the system (dead
battery or connection, faulty electric cable, faulty electric cable connection).
29 Operating Limit Light
Glows RED to indicate that an operating limit has been reached. See MLC650
Main Display Operation Manual.
30 System Fault Light
Glows AMBER to indicate that a system fault exists. See MLC650 Main Display
Operation Manual.
31 Battery Light
Glows RED when the remote control battery (A) is dead. Replace the battery.
32 Confirm Switch Move this switch UP and release it to CONFIRM the selected function.
Table 3-15. Identification and Operation of Remote Controls
Push in and lift out to remove
the battery. Reverse the step to
install a new battery.

Manitowoc MLC650 Specifications

General

Brand	Manitowoc
Model	MLC650
Category	Construction Equipment
Language	English