Metronix smartServo BL 4104-C - Page 275

15 Appendix
Group 25: Invalid device type
25-0 Invalid device type Replace the device.
25-1 Device type not
supported
25-2 Hardware revision not
supported
Load the most recent firmware.
Please contact the Technical Support team.
25-3 Device functionality
restricted
The desired functionality is not available on this
servo drive.
Please contact the Technical Support team.
25-4 Invalid power output
stage type
Load the most recent firmware.
Please contact the Technical Support team.
25-5 Incompatibility
Firmware/Hardware
The customer-specific firmware is not compatible
with the servo drive.
Please contact the Technical Support team.
Group 26: Flash
26-0 No user parameter set Load the default parameter set.
If the error is still present, replace the servo drive.
26-1 Checksum error The error cannot be eliminated by the user.
Please contact the Technical Support team.
26-2 Flash: write error
26-3 Flash: erase error
26-4 Flash: error in internal
flash
26-5 No calibration data
26-6 No user position data
sets
Save the parameter set and perform a reset.
If the error is still present, contact the Technical
Support team.
26-7 Error in data tables
(CAM)
Load the default parameter set.
If the error is still present, contact the Technical
Support team.
Group 27: Following error monitoring
27-0 Following error warning
threshold
Check the parameterisation of the following error.
Is the motor blocked?
Group 28: Operating hours meter
28-0 Missing operating hours
meter
Please contact the Technical Support team.
28-1 Operating hours meter:
write error
28-2 Operating hours meter
corrected
Acknowledge the error.
If the error recurs, contact the Technical Support
team.
28-3 Operating hours meter
converted
Group 29: SD card
29-0 No SD card The option "Transfer the parameter file after
Reset and Power on" is active, but an SD card
has not been inserted.
Insert an SD card.
Product manual BL 4000-C Page 275 of 298