15 îîAppendix
Group 18: Temperature warning threshold
18-0 Analogue motor
temperature: warning
threshold reached
Motor too hot? Check the parameterisation
(current controller, current limits).
Correct sensor?
Sensor defective?
Check the parameterisation of the sensor or the
sensor characteristics.
If the error still occurs after the sensor has been
bypassed, replace the servo drive.
Group 21: Current measurement
21-0 Error 1 current
measurement U
Please contact the Technical Support team.
21-1 Error 1 current
measurement V
21-2 Error 2 current
measurement U
21-3 Error 2 current
measurement V
Group 22: PROFIBUS
22-0 PROFIBUS: incorrect
initialisation
Is the technology module defective?
Please contact the Technical Support team.
22-2 PROFIBUS:
communication error
Check the specified slave address.
Check the bus termination.
Check the wiring.
22-3 PROFIBUS: invalid
slave address
The communication has been started with slave
address 126.
Select another slave address.
22-4 PROFIBUS: range
overflow
Mathematical error during the conversion of
physical units. The value ranges of the data and
of the physical units do not match.
Please contact the Technical Support team.
22-5 PROFIBUS: access
violation
Please contact the Technical Support team.
Group 23: Actual position saving/restoring
23-0 No usable record Failure of the actual position saving and
restoration process. Perform a homing run of the
drive.
23-1 Record with invalid
checksum
23-2 Flash content
inconsistent
Group 24: Analogue input monitoring
24-0 Analogue input above
maximum limit
Check the parameterisation of the maximum
limit.
Check the wiring.
24-1 Analogue input below
minimum limit
Check the parameterisation of the minimum limit.
Check the wiring.
Product manual BL 4000-C Page 274 of 298
To Next Page
Loading...
