96 Chapter 10: Stereo Linking
PRO2 Live Audio System
Owner’s Manual
Changing the linking options
You can choose which control options will be linked across the channel pair. There are
two ways to do this: globally and per pair. The per pair settings always override the
global ones. For details of the linked parameters for each section, see Appendix
J "Parameters Affected By Stereo Linking" on page 461.
>> To set the global default stereo linking options
1 At the GUI, choose
home
PreferencesGeneral and
then click the Linking tab to open the
Preferences Link screen (shown
right).
2 In a channel section, select the
desired default stereo linking options
and then click the Change Existing
button at the bottom of the section.
Note: Deselecting a linking option
(unticking its box) automatically
updates the status of unlinked
channels of a similar type accordingly.
However, clicking Change Existing
updates the status of all unlinked and
linked channels of a similar type.
Repeat for the other channels that
you want to change the default stereo
linking options of.
Selected control options will be linked across the channel pair of the appropriate type.
Unselected controls remain independent on each channel.
>> To set the stereo linking options for a channel pair
1 Make sure that one of the paired channels is selected and its configuration detail
area is assigned to the GUI channel strip, and then click the st. linking options
button in the GUI channel strip.
2 In the Stereo Linking Options window, select the
controls that you want to be linked across the channel pair.
3 Click CLOSE.
To Next Page
Loading...
Need help?
General
