Midas PRO2 User Manual

Simple routing to master stereo outputs 81
PRO2 Live Audio System
Owner’s Manual
6 Change the parameters of the new effect device as
necessary. For example, adjust control knobs, press
buttons etc. You can even change the effect’s name
by editing its name field (upper-left corner of effect).
You can do this via the GUI or from the I zone using
the output bay GUI (see “PRO2 control surface” on
page 18).
7 Click OK to exit. The new effect will appear in the
effects rack.
You can now patch the new effect, which will be on the
Effects tabs of both the From and To sections of the
Patching screen. For information on how to patch, see
Chapter 5 "Patching" on page 23.
Simple routing to master stereo outputs
The following shows you how to obtain audio.
>> To obtain audio
1 Make sure nothing is muted and the master faders are up.
2 In the masters section of the channel strip, press ST (stereo). You should have
audio.
channel strip

Midas PRO2 Specifications

General

Sample Rate	96 kHz
Talkback	Yes
MIDI I/O	Yes
Computer Connectivity	USB, Ethernet
Processing	40-bit floating point
Recallable Preamps	Yes
Channels	64
Matrix	8 matrix buses
Display	15" TFT display
Connectivity	Ethernet, MIDI
Type	Digital
EQ Bands	4-band parametric EQ
Inputs - Mic Preamps	8 XLR
Outputs - Main	8 XLR
Effects	Reverb, Delay, Modulation, etc.
Dynamic Processing	Gate, Compressor, Limiter
Control Surface	Motorized faders, touchscreen
Power Supply	Internal