551
PRO2 Live Audio System
Owner’s Manual
Appendix L: Service Information
The service manual for this equipment is available for purchase. Please contact your
local distributor for details.
Electrostatic discharge (ESD) precautions
Observe full electrostatic discharge (ESD) — also known as “anti-static” —
precautions when carrying out procedures in this manual that are
accompanied by the ESD Susceptibility Symbol (shown above). This
caution symbol shows you that ESD damage may be caused to items
unless proper ESD precautions are taken, which include the following
practices:
• Keep the work area free from plastic, vinyl or styrofoam.
• Wear an anti-static wrist strap.
• Discharge personal static before handling devices.
• Ground the work surface.
• Avoid touching ESD-sensitive devices.
Routine maintenance
To help keep your PRO2 Control Centre unit in good working order and to make sure it
gives you optimum performance, we recommend that you carry out the following about
once every month.
• Clean the control centre, as detailed in “Cleaning the control centre” below.
• Check controls for freedom of operation. As the controls are ‘self-cleaning’, this
operation will help to prevent them from sticking.
• Check functionality of all controls, that is, control knobs, faders, pushbuttons, LEDs
etc.
• Check functionality of equipment.
Cleaning the control centre
Switch off the control centre and electrically isolate it from the mains before cleaning.
Clean the control centre using a dry, lint-free cloth. Do not use harsh abrasives or
solvents. When cleaning the unit, take great care not to damage faders, pushbuttons
etc.
To Next Page
Loading...
Need help?
General
