Midas PRO2 User Manual

198 Chapter 23: Crossfades (Automation)
PRO2 Live Audio System
Owner’s Manual
Manually controlling a crossfade
The controls in the automation section let you manually override the crossfade.
The cancel, now and ok buttons in the automation section
Control Function during crossfade
cancel button Pauses the crossfade. Pressing the cancel button again, while the
crossfade is paused, cancels the crossfade.
Note: The level of the control on which the crossfade is operating
will remain at the point at which it was paused. If you restart the
crossfade the control will travel over the full crossfade period, that
is, if you stop (rather than pause) a five-second crossfade at two
seconds and restart it, it will take the control five seconds to move
to the final position, and not three seconds.
now button Pressing this button while the crossfade is paused (by pressing the
cancel button), continues the crossfade.
ok button Jumps to the end of the crossfade, effectively cancelling the
remaining time to the end of the crossfade.

Midas PRO2 Specifications

General

Sample Rate	96 kHz
Talkback	Yes
MIDI I/O	Yes
Computer Connectivity	USB, Ethernet
Processing	40-bit floating point
Recallable Preamps	Yes
Channels	64
Matrix	8 matrix buses
Display	15" TFT display
Connectivity	Ethernet, MIDI
Type	Digital
EQ Bands	4-band parametric EQ
Inputs - Mic Preamps	8 XLR
Outputs - Main	8 XLR
Effects	Reverb, Delay, Modulation, etc.
Dynamic Processing	Gate, Compressor, Limiter
Control Surface	Motorized faders, touchscreen
Power Supply	Internal