208 Chapter 27: Changing The Preferences
PRO2 Live Audio System
Owner’s Manual
Configuring playback
The Playback: Input Channel Source option of the
Configuration tab lets you set the record and playback
options of a virtual soundcheck.
• Lets you select the input channel source as Normal or
Tape Return via the radio buttons.
• Enable all Tape Returns — enables all tape returns.
• Disable all Tape Returns — disables all tape returns.
Restoring the PRO2 defaults
The Restore Default Preferences button will reset all console preferences,
and must be used with great caution. To alert you of the drastic
consequences of operating this button, a WARNING window appears.
The Restore Default Globals button resets all console defaults, including
patching and I/O set-up, and must be used with great caution. To alert you
to the drastic consequences of operating this button, a WARNING window
appears.
You can restore console defaults by using the options in
the Restore Defaults section of the Configuration tab.
However, these options must be used with great care.
>> To reset console preferences to default
Open the Preferences screen and click Restore Default Preferences. Acknowledge
the warning window as appropriate.
>> To reset all console settings to default
Open the Preferences screen and click Restore Default Globals. Acknowledge the
warning window as appropriate.
Checking the build information
The lower-right corner of the Configuration tab is
predominantly a service-only feature, and shows the current
build and host software versions of the PRO2 Control Centre
(typically shown right).
Using patching in automation
The Automate Patching option switches on per-scene automatic routing,
and must be used with caution. To alert you to the drastic consequences of
using this option, a WARNING window appears.
The Automate Patching option of the Show tab, when
enabled, lets you store patching information in scenes. For
information, see “Using patching in automation” on
page 171.
To Next Page
Loading...
Need help?
General
