Setting up the I/O rack device(s) 63
PRO2 Live Audio System
Owner’s Manual
Device set-up procedure
The device set-up procedure comprises:
• Selecting the port (Stage or FOH) you wish to allocate the device to.
• Selecting the device type.
• Selecting an ID for the device.
• Selecting the options (if any) for the device.
>> To add a device or change its set up
1 Click CONFIG.
2 In the AES50 Device Configuration window, click the port you want to allocate
the device to; these are listed in the far left of the window. For example, choose
“FOH Port 3 (unused)”. The text in the device type: field will change
accordingly. Ports that don’t have a device allocated to them it will have the text
“unused” inside the brackets after their name.
3 In the device type: drop-down list, click the type of device. For example,
choose “Line IO”.
4 In the device ID: drop-down list, click the ID you want for the device. For
example, choose “ID3”.
5 In the device options: drop-down list(s), choose the type of each card fitted in
the physical unit. For example, choose “Analogue 8 Input”.
Repeat for any other cards.
6 Click OK.
>> To remove a device
Select the device from the list in the left of the AES50 Device Configuration window.
Then, choose “None-Unknown” in the In the device type: drop-down list. For more
information, see “To add a device or change its set up” above.
To Next Page
Loading...
Need help?
General
