Mindray WATO EX-65 - Page 12

4
8.3.7 Calibrate the Sensor ........................................................................................... 8-7
8.4 Use a Microstream CO2 Module .................................................................................... 8-8
8.4.1 Prepare to Measure CO2 .................................................................................... 8-8
8.4.2 Make CO2 Settings ............................................................................................ 8-8
8.4.3 Measurement Limitations..................................................................................8-11
8.4.4 Scavenge the Sample Gas .................................................................................8-11
8.4.5 Zero the Sensor ................................................................................................ 8-12
8.4.6 Calibrate the Sensor ......................................................................................... 8-12
8.4.7 Oridion Information ......................................................................................... 8-12
8.5 Use a Mainstream CO2 Module.................................................................................... 8-13
8.5.1 Prepare to Measure CO2 .................................................................................. 8-13
8.5.2 Make CO2 Settings .......................................................................................... 8-14
8.5.3 Measurement Limitations................................................................................. 8-16
8.5.4 Zero the Sensor ................................................................................................ 8-16
8.5.5 Calibrate the Sensor ......................................................................................... 8-16
9 AG and O2 Concentration Monitoring .......................................................................... 9-1
9.1 Introduction..................................................................................................................... 9-1
9.2 Understand MAC Values................................................................................................. 9-2
9.3 Identify AG Modules....................................................................................................... 9-3
9.4 Prepare to Measure AG ................................................................................................... 9-3
9.5 Make AG Settings ........................................................................................................... 9-5
9.5.1 Set Anesthetic Agent .......................................................................................... 9-5
9.5.2 Set Pump Rate.................................................................................................... 9-5
9.5.3 Set O2 Compensation......................................................................................... 9-5
9.5.4 Set Working Mode.............................................................................................. 9-5
9.5.5 Set CO2 Unit...................................................................................................... 9-6
9.5.6 Restore Defaults................................................................................................. 9-6
9.5.7 Set CO2 Waveform ............................................................................................ 9-6
9.6 Change Anesthetic Agent ................................................................................................ 9-6
9.7 Measurement Limitations................................................................................................ 9-7
9.8 Troubleshooting .............................................................................................................. 9-7
9.9 Scavenge the Sample Gas ............................................................................................... 9-8
9.10 Calibrate the AG Module .............................................................................................. 9-8
10 BIS Monitoring............................................................................................................. 10-1
10.1 Introduction................................................................................................................. 10-1
10.2 Identify the BIS Module.............................................................................................. 10-1
10.3 Safety Information ...................................................................................................... 10-2
10.4 Understand BIS Parameters ........................................................................................ 10-3
10.5 Prepare to Measure BIS .............................................................................................. 10-4
10.6 Continuous Impedance Check..................................................................................... 10-5
10.7 Cyclic Impedance Check............................................................................................. 10-6
10.8 BIS Sensor Check Window......................................................................................... 10-6