EasyManuals Logo

Mindray WATO EX-65 Operator's Manual

Mindray WATO EX-65
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #171 background imageLoading...
Page #171 background image
13-19
NOTE
z The sodalime which is poured in cannot exceed the level marked
on the sodalime canister.
13.2 Install the Breathing Tubes
NOTE
z When installing the breathing tube, hold the tube connector at both ends of the
tube to prevent damage of the tube.
z Do not reuse the filter to prevent cross-contamination.
z Install the filter as described in this manual to prevent dust and particles from
entering the patient’s lungs and prevent cross-contamination.
1. The following figure shows the filter at the patient connection.
2. Connect the two ends of the breathing tubes to the inspiration/expiration connectors on
the breathing system.

Table of Contents

Other manuals for Mindray WATO EX-65

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mindray WATO EX-65 and is the answer not in the manual?

Mindray WATO EX-65 Specifications

General IconGeneral
TypeAnesthesia Machine
ModelWATO EX-65
BrandMindray
Tidal Volume Range20 to 1500 mL
O2 Concentration21% to 100%
I:E Ratio4:1 to 1:8
Ventilation ModesVCV, PCV, SIMV, Manual, Spontaneous
Flow MeterO2, N2O
VaporizerUp to 2 vaporizers
PEEP0 to 20 cmH2O
Gas SupplyO2, N2O, Air
MonitoringAirway Pressure, Flow, Volume
O2 Flush35 to 75 L/min
Respiratory Rate4 to 100 breaths per minute
Power Supply100 to 240 VAC, 50/60 Hz
Fresh Gas Flow0 to 15 L/min

Related product manuals