11-6
WARNING
z Take care to set [CPB] to [ON] because some physiological alarms are not
triggered under this setting. These disabled physiological alarms include: apnea
alarm, Volume Apnea>2 min, Paw too low, TVe too high, TVe too low, MV too
high, MV too low, Rate too high, Rate too low, EtCO2 too low, FiCO2 too low,
EtN2O too low, FiN2O too low, EtHal too low, FiHal too low, EtEnf too low, FiEnf
too low, EtIso too low, FiIso too low, EtSev too low, FiSev too low, EtDes too low
and FiDes too low.
11.7 Set MV&TVe Alarm
1. Push the MV&TVe alarm key when MV&TVe alarm is turned on. The message
[MV&TVe Alarm Off] is prompted and the icon
is displayed on the
screen.
2. Push the MV&TVe alarm key again and the message [MV&TVe Alarm On] is
prompted.
WARNING
z MV&TVe alarm is not triggered when MV&TVe alarm is turned off. Exert care
when using MV&TVe alarm.
11.8 Set Apnea Alarm
In non-mechanical ventilation mode:
1. Push the MV&TVe alarm key when apnea alarm is turned on. The message [Apnea
Alarm Off] is prompted and the icon
is displayed on the screen.
2. Push the MV&TVe alarm key again and the message [Apnea Alarm On] is prompted.
When apnea alarm is turned off, if the anesthesia machine detects breathing waveforms, the
system automatically turns on apnea alarm.