3-5
Displays information about system operating state.
18 Parameter&graph area
Displays the parameters, waveforms, spirometry loops, or electronic flowmeter graphs
which the anesthesia ventilator, gas module or BIS module monitors. Different types of
screens are displayed based on the actual system configuration or screen layout settings.
For details, refer to 5 User Interface and Parameter Monitoring.
3.3 Basic Settings
This chapter covers only general settings of the anesthesia machine, such as language, screen
brightness, system time etc. Parameter settings and other settings can be referred to in the
respective sections.
3.3.1 Adjust Screen Brightness
1. Select the [User Setup] shortcut key and select [Screen and Audio Setup >>].
2. Select [Screen Brightness] and select the appropriate value (ranging from 1 to 10) for
screen brightness. The value 10 is for the brightest and 1 the least bright. If the
anesthesia machine is battery powered, you can select less brightness to save battery
capacity.
3.3.2 Adjust Sound Volume
3.3.2.1 Key Sound Volume
1. Select the [User Setup] shortcut key and select [Screen and Audio Setup >>].
2. Select [Key Sound Volume] and select the appropriate value (ranging from 0 to 10) for
key sound volume. The value 0 is for audio off and 10 for the loudest.
3.3.2.2 Alarm Sound Volume
1. Select the [User Setup] shortcut key and select [Screen and Audio Setup >>].
2. Select [Alarm Sound Volume] and select the appropriate value (ranging from 1 to 10)
for alarm sound volume. The value 1 is for the lowest and 10 for the loudest.