3 Calibration
38
CAUTION
The measuring weight does not accept [0]. When you select [0] and press ,
flashing appears and then reappears.
For setting procedures with and , see Section 1.6, "Basic key operation".
3. Press .
▼ Setting of weight mass
(After the setting of measuring weight)
1. After confirming is displayed, press .
The currently set weight mass appears, and the number in the last digit flashes.
2. Using and , set the weight mass.
CAUTION
The weight mass does not accept a value exceeding the measuring weight or [0].
When you select either value and press , flashing appears and
then reappears.
POINT
The weight mass used in the calibration should weigh at least two-thirds of the measuring
weight.
When it is possible to prepare a weight whose mass is equal to the measuring weight, set the
weight mass to a value equal to the measuring weight.
3. Press .
▼ Zero calibration
(After the setting of weight mass)
1. Confirm is displayed.
2. Place the tare or equivalent weight on the measuring unit.
3. Press .
flashes and the zero calibration is initiated.
Upon completion of zero calibration, appears.
To Next Page
Loading...
Need help?
General
