FIXING UNIT
2 - S - 4
4. Replacing the Oil Pad
a. Procedure
(1) Remove the fixing unit.
(2) Remove the set screw, then remove the fixing cover.
(3) Remove the E ring, then remove the upper paper exit
roller unit.
(4) Remove the four set screws, then remove the upper
fixing cover.
5. Replacing the Fixing Cleaning Roller and Oil
Apply Impregnated Roller
Caution:
1. Push the fixing unit cleaning roller and the CL shaft
firmly against each other.
2. Push down the bearing and fix it in place.
3. When re-installing the roller, tighten the hex bolts to a
higher torque than normal.
a. Procedure
(1) Remove the fixing unit.
(2) Remove the set screw, then remove the fixing cover
(3) Remove the paper exit roller upper unit, then remove
the upper fixing cover and the oil pad.
(4) Slacken the four hex screws fixing the bearing.
(5) Open the oil pad to the upper side, then slide it left and
right, and remove it.
Upper fixing cover
Set screws
Set screw
Upper paper exit
roller unit
Set screw
E ring
Oil pad
(6) Re-install the oil pad in the opposite sequence to
removal.
Hex screws
Hex screws
Hex screws
Oil apply roller
Hex screws
Bearing casing (back side)
Bearing casing
(front side)
Fixing cleaning roller
(7) Re-install the oil pad in the opposite sequence to
removal.
(5) Remove the two hex mounting screws, then pull out
the shaft, and remove the fixing cleaning roller.
(6) Remove the two hex mounting screws, then pull out
the shaft and remove the oil apply roller.
Bearing
Bearing
FIXING UNIT-1
To Next Page
Loading...