Moog Animatics SmartMotor™ Developer's Guide,Rev. L
Page 734 of 909
TALK1
Talk on Communications Port 1
APPLICATION: Communications control
DESCRIPTION: Motor restored to print on channel 0
EXECUTION: Immediate
CONDITIONAL TO: N/A
LIMITATIONS: N/A
READ/REPORT: N/A
WRITE: N/A
LANGUAGE ACCESS: N/A
UNITS: N/A
RANGE OF VALUES: N/A
TYPICAL VALUES: N/A
DEFAULT VALUE: TALK1 state
FIRMWARE VERSION: 5.0.x, 5.16.x or 5.32.x series only
COMBITRONIC: N/A
DETAILED DESCRIPTION:
NOTE: This command is typically sent from a host rather than existing within a
SmartMotor program.
The TALK1 command restores the motor’s ability to print messages to the serial
communication channel 1 if that ability was previously suppressed with the SILENT1
command. This command is typically used following the download of a user program to a
SmartMotor™ within a daisy chain. It could also be used to "un-silence" a debug routine.
TALK1 may be issued from the terminal or within a user program. However, the command is
typically sent from a host.
EXAMPLE: (Shows use of SILENT1 and TALK1)
RUN? 'Wait here for the RUN command.
'Set a=1 in the Terminal window to allow print statements.
OCHN(RS4,1,N,9600,1,8,C) 'Open ports 4 and 5 as RS-485 channel 1.
WHILE 1 'Endless loop.
IF a==1 TALK1 ENDIF 'If variable a is set to 1, allow
'PRINT statements on channel 1.
IF a==0 SILENT1 ENDIF 'If variable a is set to 0, suppress
'PRINT statements on channel 1.
PRINT1("Position=",PA,#13) 'Print the actual position.
WAIT=3000 'Wait 3 seconds.
LOOP 'Loop back to WHILE 1 command.
END
Part 2: Commands: TALK1
To Next Page
Loading...
Need help?
General
