3-98
Unique Switch 072 — Operation
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 1 Factory use only
4 0 Factory use only
3 1 Effect charge setting in
department mode
0: No
1: Yes
When this bit is set to “1”, the following available:
Input the price rate per page for transmission
Print transmission charge on the department list
2 0 Send service report
1: No
2: Yes
1 0 Factory use only
0 0 Factory use only
Unique Switch 073 — Factory use only
Unique Switch 074 — Operation
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Prohibit double registration
0: No
1: Yes
When set to “0”, the same phone number can be
registered in the address book.
2 1 Priority of consumable order
sheet printing
0: Print after the current
printing job is completed
1: Print immediately
When the drum cartridge has reached its design life,
or the toner cartridge is empty, the machine prints a
consumable order sheet.
When this switch is set at “0”, the machine will
not print consumable order sheet until the current
printing job is finished.
1 0 Print the transmission time
on TCR
0: Print the transmit time
1: Blank
When set to “0”, the transmission time will be
printed on TCR.
0 1 When receive a fax message
during Auto power off mode,
the LCD will be in standby
mode
0: No
1: Yes
Unique Switch 075 — Factory use only
To Next Page
Loading...
Need help?
General
