3-101
Unique Switch 085 — Miscellaneous
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Print/Send the consumable
order sheet when the drum is
near end
0: Yes
1: No
Note: For this feature to work correctly, you must
register several items. See “3.16 Consumable
order sheet” page 3-126.
5 0 Print/Send the consumable
order sheet when toner is
near empty
0: Yes
1: No
Note: For this feature to work correctly, you must
register several items. See “3.16 Consumable
order sheet” page 3-126.
4 0 Factory use only
3 0 “Next doc” default setting
when scanning with ADF
0: No
1: Yes
Determine the default setting for “Next doc”
scanning with ADF.
If it is set to “0” the default setting for Next doc is
“No”, if is “1” the setting is “Yes”.
2 1 “Next doc” default setting
when scanning with FBS
0: No
1: Yes
Determine the default setting for “Next doc”
scanning with FBS.
If it is set to “0” the default setting for Next doc is
“No”, if is “1” the setting is “Yes”.
1 0 Factory use only
0 0 Multi T.30 monitor journal
0: No
1: Yes
If this setting is “Yes”, the journal report will be
printed not in the sequence number but in the table
number to see the T.30 monitor.
Unique Switch 086 — Factory use only
Unique Switch 087 — Miscellaneous
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Factory use only
2 0 Print the sending document
on the error massage sheet
0: No
1: Yes
1 0 Factory use only
0 0 Factory use only
To Next Page
Loading...
Need help?
General
