NEC SL1100 - Section 3 HOW to ENTER PROGRAMMING MODE; Section 4 HOW to EXIT PROGRAMMING MODE

pressed. To learn how to enter the programming mode, refer to How to Enter Programming Mode on
page 1-2.
SECTION 3 HOW TO ENTER PROGRAMMING MODE
To enter programming mode :
1. Go to any working display telephone.
In a newly installed system, use extension (port 1).
2. Do not lift the handset.
3. Press Speaker.
4. #
*
#
*
.
5. Dial the system password + Hold.
Refer to the following table for the default system passwords. To change the passwords, use
90-02 : Programming Password Setup on page 2-533.
Program Mode
Base Service OP1 OP2
Password User Name Level Programs at this Level
******
necam 1 (MF) Manufacture Level (MF) :
80-02, 80-03, 80-04, 80-05, 80-07, 80-10, 81-04, 81-05, 82-01, 82-04,
82-05, 82-08
12345678 sltech 2 (IN) Installation (IN) :
All programs in this section not listed for MF, SA, & SB
0000 ADMIN1 3 (SA) System Administrator - Level 1 (SA) :
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17, 10-18, 10-23,
10-24, 10-25, 10-28, 10-29, 10-45, 12-02, 12-03, 12-04, 12-08, 15-01,
15-07, 15-09, 15-10, 15-11, 20-16, 20-34, 21-07, 21-14, 22-04, 22-11,
22-17, 25-08, 30-03, 30-04, 32-02, 45-02, 84-22, 90-03, 90-04, 90-06,
90-07, 90-19, 90-57, 90-58, 90-59, 90-65
9999 ADMIN2 4 (SB) System Administrator - Level 2 (SB) :
13-04, 13-05, 13-06, 13-11, 15-14, 21-20
SECTION 4 HOW TO EXIT PROGRAMMING MODE
To-exit the programming mode :
When you are done programming, you must be out of a program option to exit (pressing the Mute key
will exit the program option).
1. Press Mute key to exit the program options, if needed.
Program Mode
Base Service OP1 OP2
2. Press Speaker. If changes were to the system programming, "Saving System Data" is displayed.
SL1100
ISSUE 6.0
1-2
Introduction