NEC SL1100 - Program 35: SMDR Account Code Setup; SMDR Options

Program 35 : SMDR Account Code Setup
35-01 : SMDR Options
Level:
IN
Description
Use Program 35-01 : SMDR Options to set the SMDR (Station Message Detail Recording) options
for each of the eight SMDR ports. Refer to the following chart for a description of each option, its
range and default setting.
Input Data
SMDR Port Number 1 ~ 2
Item
No.
Item Input Data Description Default
01 Output Port Type 0 = No Setting (SMDR
disabled)
3 = LAN (SMDR enabled
and sent out of the LAN
port.)
This option specifies the type of connec-
tion used for SMDR. The baud rate for the
COM port should be set in Program
10-21-02 or 15-02-19.
SMDR port1 : 3
SMDR port2 : 0
03 Header Language 0 = English
1 = German
2 = French
3 = Italian
4 = Spanish
Specify the language in which the SMDR
header should be printed.
0
04 Omit Digits 0 ~ 24 (0 = Not applied) The number of digits entered in this option
does not print on the SMDR report. For ex-
ample, if the entry is 10, the first 10 digits a
user dials do not appear on the SMDR re-
port.
0
05 Minimum Digits 0 ~ 24 (0 = Not applied) Outgoing calls must be at least this num-
ber of digits for inclusion in the SMDR re-
port.
0
06 Minimum Call Dura-
tion
0 ~ 65535 seconds (0 =
All)
The duration of the call must be at least
this time to be included on the SMDR re-
port.
0
07 Minimum Ring Time
(For Incoming Calls)
0 ~ 65535 seconds (0 =
All)
A call must ring for at least this time to be
included on the SMDR report.
0
08 Format Selection 0 = Format1 Type (North
America)
1 = Format2 Type (Over-
seas)
0
Conditions
None
ISSUE 6.0
SL1100
Programming Manual 2-349
Program
35