NEC SL1100 - FAX over IP CODEC Setup

Program 84 : Hardware Setup for VoIPDB
84-32 : FAX Over IP CODEC Setup
Level:
IN
(This Program is available for V4.0 or higher)
Description
Use Program 84-32 : FAX Over IP CODEC Setup to program the CODECs used when faxing across
SIP Trunk. Note these settings must match in both systems for faxing across SIP Trunk to work.
Input Data
Type
(V5.0 Added)
1 = Reserved
2 = SIP Trunk Profile 1
3 = SIP Trunk Profile 2
4 = Reserved
Item
No.
Item Input Data Description Default
01 FAX CODEC 1 = G.711 a-law
2 = G.711 u-law
3 = G.726
(SIP Profile:1-2) (V5.0
Added)
When the G.711 a-
law is selected in
Item 01, it is possi-
ble to set "8".
When the G.711 u-
law is selected in
Item 01, it is possi-
ble to set "0".
When the G.726 u-
law is selected in
Item 01, it is possi-
ble to set "2". (V5.0
Added)
Set up FAX over IP CODEC. 2
02 Payload Size 1 ~ 4 (10 ms base)
(SIP Profile:1-2) (V5.0
Added)
Set up payload size when using SIP Trunk. 2
03 Jitter Buffer Mode 1 = Static
2 = Self adjusting
(SIP Profile:1-2) (V5.0
Added)
Set up Jitter Buffer settings when using
SIP Trunk.
1
04 Jitter Buffer (min) 0 ~ 300
(SIP Profile:1-2) (V5.0
Added)
Set up minimum Jitter Buffer settings when
using SIP Trunk.
20
05 Jitter Buffer (average) 0 ~ 300
(SIP Profile:1-2) (V5.0
Added)
Set up average Jitter Buffer settings when
using SIP Trunk.
40
06 Jitter Buffer (max) 0 ~ 300
(SIP Profile:1-2) (V5.0
Added)
Set up maximum Jitter Buffer settings
when using SIP Trunk.
80
ISSUE 6.0 SL1100
Programming Manual 2-529
Program
84